Rod seal B-NEI-FPM

  • Image_1 Image_1
  • Image_2 Image_2


Anwendung Hydraulics
Design rod seal
Installation in closed grooves A, in open grooves B
Material (1) Seal: FPM, (2) Support ring: acetal resin / PTBR
Max. operating pressure up to 400 bar
Media Mineral oil, Water emulsions
Sliding speed max. 0.5 m/s
Temp. max. 110 °C
Temp. min. -30 °C


Low-friction seal.
Extremely good sealing effect at low pressure.
Simple solution.

Article Table

Product Name D mm d mm L mm
Product Name D mm d mm L mm
B216157-NEIFPM 55 mm 40 mm 8.0 mm
B295236-NEIFPM 75 mm 60 mm 13.0 mm
B314236-NEIFPM 80 mm 60 mm 14.5 mm
B334275-NEIFPM 85 mm 70 mm 12.5 mm
B452393-NEIFPM 115 mm 100 mm 12.5 mm

Order hints

Bei besonderen Betriebsbedingungen (Flüssigkeit, Temperatur, Druck ...) wenden Sie sich bitte an uns.


Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.