DAS

Piston packing set for one-piece pistons DAS

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Application Hydraulics
Design Piston packing set
Installation on one-piece pistons A
on multi-part pistons B
Material (2) Guide ring: acetal resin
(1) Seal: NBR
(3) Support ring: Polyester
Max. operating pressure up to 300 bar
Media Mineral oil
Water emulsions
Sliding speed max. 0.5 m/s
Temp. max. 110 °C
Temp. min. -30 °C

Description

Extremely good sealing effect at low pressure.
Easy assembly.
Simple solution.

Article Table

Product Name D mm G mm P mm M mm d mm L mm
Product Name D mm G mm P mm M mm d mm L mm
DAS 30 17 30 6.35 28.50 26.50 17 15.4
DAS 40 24 40 6.35 38.50 35.40 24 18.4
DAS 40 30 40 6.35 38.50 35.40 30 16.4
DAS 50 34 50 6.35 48.66 45.41 34 18.4
DAS 60 44 60 6.35 58.65 55.39 44 18.4
DAS 63 47 63 6.35 61.63 58.39 47 18.4
DAS 70 50 70 6.35 68.34 64.18 50 22.4
DAS 80 60 80 6.35 78.34 74.16 60 22.4
DAS 90 70 90 6.35 88.31 84.15 70 22.4
DAS 100 75 100 6.35 98.05 93.14 75 22.4
DAS 110 85 110 6.35 108.00 103.10 85 22.4
DAS 125 100 125 6.35 122.96 118.08 100 25.4
DAS 130 105 130 9.50 127.50 122.60 105 25.4
DAS 140 115 140 9.50 137.50 132.60 115 25.4
DAS 150 125 150 9.50 147.50 142.60 125 25.4
DAS 160 135 160 9.50 157.50 152.60 135 25.4
DAS 180 155 180 12.70 177.10 171.72 155 25.4
DAS 200 175 200 12.70 197.00 191.62 175 25.4
DAS 220 195 220 12.70 217.00 211.62 195 25.4

Order hints

Alternative material possible: FPM.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.