DGS 90

Rotary fitting, angle 90°, ball bearing



Properties

Connection 1 metric cylindrical outer thread
Connection 2 metric cylindrical outer thread
Construction type Ball bearing
Design Rotary fitting (bulkhead connector)
Construction Angle 90°
Sealing form 1 24° inner cone
Sealing form 2 24° inner cone
Scope of supply Socket (without union nut and cutting ring)
Surface electro galvanised
Material Steel

Hints

Information about fitting, installation, pressure loads and permissible operating temperatures can be found in the technical information for pipe fittings.

Article Table

Product Name Series Operating pressure External pipe Ø mm M D mm L2 mm l2 mm l3 mm L4 mm l4 mm S1 S3 S6
Product Name Series Operating pressure External pipe Ø mm M D mm L2 mm l2 mm l3 mm L4 mm l4 mm S1 S3 S6
DGS 90 NW03 HS S PN 250 6 M 14 x 1.5 5 31 16,0 16,0 70,0 39,5 22 17 19
DGS 90 NW04 HS S PN 250 8 M 16 x 1.5 5 32 17,0 16,0 70,0 39,5 22 17 22
DGS 90 NW08 HS S PN 250 12 M 20 x 1.5 5 38 21,5 15,5 83,0 51,0 30 22 27
DGS 90 NW13 HS S PN 250 16 M 24 x 1.5 5 43 24,5 17,5 85,0 49,0 30 22 32
DGS 90 NW16 HS S PN 250 20 M 30 x 2 15 48 26,5 28,5 117,5 67,0 41 36 41
DGS 90 NW20 HS S PN 250 25 M 36 x 2 15 54 30,0 30,0 119,5 65,0 41 36 46
DGS 90 NW25 HS S PN 250 30 M 42 x 2 15 62 35,5 30,5 140,0 82,5 60 50 50
DGS 90 NW32 HS S PN 250 38 M 52 x 2 15 72 41,0 31,0 142,0 80,5 60 50 65

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.