DS -M

Piston seal DS-M



Properties

Application Hydraulics
Design U-ring packing set
Media Mineral oils, Water emulsions
Material (2) Seal: fabric-reinforced NBR, (4) Back ring: NBR fabric laminate
Installation on multi-part pistons
Operating pressure up to 400 bar

Description

Low spatial requirement.
High resistance to extrusion.

Article Table

Product Name D mm d mm L mm
Product Name D mm d mm L mm
DS 157 098-M 40 25 10,0
DS 196 137-M 50 35 10,0
DS 236 177-M 60 45 10,0
DS 248 188-M 63 48 10,0
DS 314 236M 80 60 13,0
DS 393 314-M 100 80 13,0
DS 433 354-M 110 90 13,0
DS 452 354-M 115 90 16,0
DS 452 374-M 115 95 13,0
DS 492 393-M 125 100 16,2
DS 551 452-M 140 115 16,2
DS 590 472-M 150 120 19,8
DS 629 511-M 160 130 19,8
DS 708 590-M 180 150 19,8

Order hints

For special operating conditions (fluid, temperature, pressure ...) please contact us.
Alternative material possible: FPM.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.