GA FPM

Wiper GA-FPM

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Anwendung Hydraulics
Design Wipers
Installation is pressed into an open groove
Material (1) Sleeve: Steel, Wiper: FPM
Media Mineral oil, Water emulsions
Sliding speed max. 0.5 m/s
Temp. max. 200 °C
Temp. min. -20 °C

Description

Low spatial requirement.
No penetration of dirt via the outer metal ring.
Simple solution.

Article Table

Product Name D mm H mm d mm L mm
Product Name D mm H mm d mm L mm
GA1622-3FPM 22 mm 4 mm 16 mm 3.0 mm
GA2535-7FPM 35 mm 10 mm 25 mm 7.0 mm
GA3040-7FPM 40 mm 10 mm 30 mm 7.0 mm
GA3245-4FPM 45 mm 8 mm 32 mm 4.0 mm
GA4555-7FPM 55 mm 10 mm 45 mm 7.0 mm
GA4560-7FPM 60 mm 10 mm 45 mm 7.0 mm
GA5056-5FPM 56 mm 8 mm 50 mm 5.0 mm
GA6070-7FPM 70 mm 10 mm 60 mm 7.0 mm
GA6375-7FPM 75 mm 10 mm 63 mm 7.0 mm
GA7080-7FPM 80 mm 10 mm 70 mm 7.0 mm

Order hints

Bei besonderen Betriebsbedingungen (Flüssigkeit, Temperatur, Druck ...) wenden Sie sich bitte an uns.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.