Properties

Installation insert into the groove
Material Guide ring: Polyester resin - synthetic fibre fabric laminate with graphite
Media Mineral oil
Water emulsions
Pressure resistance as DIN 53454 (N/mm2) 350 N/mm²
Sliding speed max. 1.0 m/s
Surface pressure 50 N/mm²
Temp. max. 130 °C
Temp. min. -40 °C

Description

Available by the metre.
Easy working of the fitting groove and assembly.
Low coefficient of friction.
High load-bearing capacity.

Hints

Calculation of shear force; F= p x D x L x n
F= maximum shear force (N)
p = maximum surface pressure (N/mm2)
D x L= projected area (mm2)
n= quantity of rings

Article Table

Product Name L mm e mm
Product Name L mm e mm
GTH 25 056 5.6 2.5
GTH 25 097 9.7 2.5
GTH 25 150 15.0 2.5
GTH 25 200 20.0 2.5
GTH 25 250 25.0 2.5
GTH 30 097 9.7 3.0
GTH 30 128 12.8 3.0
GTH 30 150 15.0 3.0
GTH 30 192 19.2 3.0
GTH 30 200 20.0 3.0
GTH 30 250 25.0 3.0
GTH 30 300 30.0 3.0
GTH 35 300 30.0 3.5
GTH 40 097 9.7 4.0
GTH 40 128 12.8 4.0
GTH 40 150 15.0 4.0
GTH 40 200 20.0 4.0
GTH 40 250 25.0 4.0

Order hints

For special operating conditions (fluid, temperature, pressure ...) please contact us.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.