Installation insert into the groove
Material Guide ring: Polyester resin - synthetic fibre fabric laminate with graphite
Media Mineral oil
Water emulsions
Pressure resistance as DIN 53454 (N/mm2) 350 N/mm²
Sliding speed max. 1.0 m/s
Surface pressure 50 N/mm2
Temp. max. 130 °C
Temp. min. -40 °C


Available by the metre.
Easy working of the fitting groove and assembly.
Low coefficient of friction.
High load-bearing capacity.


Calculation of shear force; F= p x D x L x n
F= maximum shear force (N)
p = maximum surface pressure (N/mm2)
D x L= projected area (mm2)
n= quantity of rings

Article Table

Product Name e L e mm L mm
Product Name e L e mm L mm
GTH 31 095 1/8" 3/8" 3.18 9.53
GTH 31 127 1/8" 1/2" 3.18 12.70
GTH 31 159 1/8" 5/8" 3.18 15.87
GTH 31 191 1/8" 3/4" 3.18 19.05
GTH 31 254 1/8" 1" 3.18 25.40

Order hints

For special operating conditions (fluid, temperature, pressure ...) please contact us.


Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.