HD 600 (R13)

HD hose


Properties

Outer layer synthetic rubber with high temperature, ozone and abrasion resistance
Insert six high tensile steel wire spiral inserts
Application High pressure circuits with high loads, hydrostatic drives
Colour black
Inner layer oil resistant synthetic rubber
Elongation + 2 % to - 2 %
Media Glycol, Mineral oil, Water (0°C to + 70°C), Water-oil emulsions
Standard EN 856 R 13

Hints

The change in length of the hose is determined at max. working pressure during testing to EN ISO 1402.

Article Table

Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm Ø Insert min. mm Ø Insert max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm Ø Insert min. mm Ø Insert max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
HD 650 51 32 2" 50,4 52,0 66,9 69,3 69,5 72,7 345,0 690 1379 630
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.