HK 92RV 04 BG2

Gear flow divider, size 2 92RV 4-way

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Design with one phase compensation valve and anti-cavitation valve per section
Adjustment range DBV: 70-210 bar
external leak oil discharge
Pressure difference max. 30 bar (between the sections)
Recommended speed 1800 - 2000 rpm
Rotational speed range 1200 - 2500 U/min

Description

This flow divider is used to supply four independent hydraulic circuits with just one pump
Division error approx. 3%
Different pressure settings for each section possible
Valves settable from 70-210 bar, other setting ranges on request
Modification to internal leak oil discharge possible - For this, close off port T with G1/2" blind plug (modification recommended only after consultation!)
After modification to internal leak oil discharge, the integrated suction valves are decommissioned
Configuration of gear flow dividers: qi = Q/z * 1000/n
qi = displacement/section [cm3]; Q = total intake volumetric flow [l/min]; z = no. of sections; n = rotating speed [rpm]

Hints

Before commissioning the system, the first running-in of the gear flow divider should be under no load.
Diagrams and circuit diagrams essentially valid as schematic diagrams also for 4-way flow dividers.

Article Table

Product Name p1max. bar Weight kg A mm Flow per element typ. l/min Intake volume per section cm³ Li mm Flow per element max. l/min Flow per element min. l/min p2max. bar
Product Name p1max. bar Weight kg A mm Flow per element typ. l/min Intake volume per section cm³ Li mm Flow per element max. l/min Flow per element min. l/min p2max. bar
HK 92RV 04 B 41 210 11.1 47 7.60 4.00 444 10.00 4.80 260
HK 92RV 04 B 43 210 11.8 50 10.80 6.00 456 15.00 7.20 260
HK 92RV 04 B 45 210 12.4 54 15.10 9.00 472 22.50 10.80 260
HK 92RV 04 B 47 210 13.0 58 19.40 11.00 488 27.50 13.20 260
HK 92RV 04 B 49 200 13.7 64 25.90 14.00 512 35.00 16.80 230
p1 = max. working pressure
p2 = max. peak pressure

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.