HK CB L

Overcentre valve CB

Properties

Max. operating pressure max. 350 bar

Description

load-holding function to 210bar (with setting 280 bar, opening of load pressure 0 bar)
Load-dependent opening for controlling negative (dragging) loads
back pressure on connection 2 can impair the functioning of the valve
closing pressure = 85% of the opening pressure
Note! Relief function by screwing in the spindle

Hints

These valves must be set according to the application.

Article Table

Product Name Screw-in housing Weight kg Qmax l/min Tightening torque Nm A mm AF mm Pressure setting range max. bar B mm Pressure setting range min. bar Level control ratio Screw-in thread
Product Name Screw-in housing Weight kg Qmax l/min Tightening torque Nm A mm AF mm Pressure setting range max. bar B mm Pressure setting range min. bar Level control ratio Screw-in thread
HK CB BY LHN HK EBAM
HK EBAT
HK EBY
HK EBYS
HK YEU
0.5 20 50.0 50.0 22 280 35.0 70 1:2 T-11A
HK CB CA LIN HK EBAM
HK EBAT
HK EBY
HK EBYS
HK YEU
0.5 60 50.0 50.0 22 105 35.0 25 1:3 T-11A
HK CB CA LHN HK EBAM
HK EBAT
HK EBY
HK EBYS
HK YEU
0.5 60 50.0 50.0 22 280 35.0 70 1:3 T-11A
HK CB EA LIN HK BCV
HK BCVS
HK BCW
HK BCWS
HK YAV
0.5 120 65.0 61.0 28 105 35.0 25 1:3 T-2A
HK CB EA LHN HK BCV
HK BCVS
HK BCW
HK BCWS
HK YAV
0.5 120 65.0 61.0 28 280 35.0 70 1:3 T-2A

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.