HK EPM CD

EPM gerotor motor

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Connection Oil fittings: A + B = G 1/2"
Design Standard variant
Type "CD" with high-pressure gasket
Shaft Ø 25mm
two hole flange bolt circle 106.4
Intake and return pressure with leak oil line max. 175 bar
Leak oil connection G 1/4"

Article Table

Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
HK EPM 025 CD 100 75 5.6 133 50 20 33 150 1600 40 25.0 20
HK EPM 032 CD 100 75 5.6 135 50 20 43 150 1560 50 32.0 15
HK EPM 040 CD 120 75 5.8 135 50 20 62 150 1510 60 39.7 10
HK EPM 050 CD 140 75 5.8 136 50 20 94 150 1210 60 49.5 10
HK EPM 080 CD 140 75 5.9 140 50 20 150 150 755 60 79.2 10
HK EPM 100 CD 140 75 6.1 141 50 20 190 150 605 60 99.0 10
HK EPM 125 CD 140 75 6.2 145 50 - 230 150 486 60 123.8 10
HK EPM 160 CD 140 75 6.4 150 50 - 310 150 378 60 158.4 10
HK EPM 200 CD 140 75 6.6 155 50 - 360 150 303 60 198.0 10
HK EPM 250 CD 110 75 6.8 162 - - 380 150 242 60 247.5 10
HK EPM 315 CD 90 75 7.1 171 - - 380 150 190 60 316.8 10
HK EPM 400 CD 70 75 7.6 182 - - 380 150 150 60 396.0 10
HK EPM 500 CD 60 75 9.0 195 - - 390 150 120 60 495.0 10
HK EPM 630 CD 55 - 9.5 213 - - 440 150 95 60 623.0 10
Values for torque and pressure drop apply for continuous operation
max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.