HK EPMM C

EPMM gerotor motor

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Connection Oil fittings at rear: A + B = G 3/8"
Design Standard variant
Type "C" with standard seal
Shaft Ø 16mm
Intake and return pressure with leak oil line max. 140 bar
Leak oil connection G 1/4"

Hints

It is generally recommended that the leak oil line is connected!

Article Table

Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
HK EPMM 008 C 100 100 1.9 104 40 20 11 140 1950 16 8.2 50
HK EPMM 012 C 100 100 2.0 106 40 20 16 140 1550 20 12.9 40
HK EPMM 020 C 100 100 2.1 109 40 20 25 140 1000 20 20.0 30
HK EPMM 032 C 100 100 2.2 114 40 - 40 140 630 20 31.8 30
HK EPMM 040 C 80 100 2.3 118 40 - 41 140 500 20 40.0 25
HK EPMM 050 C 70 100 2.4 122 - - 45 140 400 20 50.0 20
Values for torque and pressure drop apply for continuous operation
max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.