HK EPMS

EPMS geroller motor



Properties

Connection Oil connectors: A + B = G 1/2"; leak oil = G 1/4"
Design Four hole flange bolt circle 106,4, Shaft Ø 32mm, Standard variant, Type "C" with standard seal

Hints

It is generally recommended that the leak oil line is connected!

Article Table

Product Name Flow rate max. L/min Displacement cc Speed min. rpm Speed max. rpm Torque max. N-m Pressure drop max. bar Pmax. at
0-100
rpm bar
Pmax. at
100-300
rpm bar
Pmax. at
>300 rpm bar
L mm Weight kg
Product Name Flow rate max. L/min Displacement cc Speed min. rpm Speed max. rpm Torque max. N-m Pressure drop max. bar Pmax. at
0-100
rpm bar
Pmax. at
100-300
rpm bar
Pmax. at
>300 rpm bar
L mm Weight kg
HK EPMS 100 C 75 100,0 10 750 290 175 100 50 20 169 10,0
HK EPMS 125 C 75 125,7 8 600 370 175 100 50 20 174 10,3
HK EPMS 160 C 75 159,7 8 470 460 150 100 50 20 180 10,7
HK EPMS 200 C 75 200,0 8 375 460 140 100 50 20 187 11,1
HK EPMS 250 C 75 250,0 8 300 500 125 100 50 - 195 11,6
HK EPMS 315 C 75 314,9 8 240 540 120 100 50 - 207 12,3
HK EPMS 400 C 75 397,0 8 185 580 100 100 50 - 221 13,2
Values for torque and pressure drop apply for continuous operation - pmax = max. pressure - max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.