HK EPMT

EPMT geroller motor



Properties

Connection Oil fittings: A + B = G 3/4"; leak oil = G 1/4"
Design Four hole flange bolt circle 160, Shaft Ø 40mm, length 79mm, Standard variant, Type "C" with standard seal

Hints

It is generally recommended that the leak oil line is connected!

Article Table

Product Name Flow rate max. L/min Displacement cc Speed min. rpm Speed max. rpm Torque max. N-m Pressure drop max. bar Pmax. at
0-100
rpm bar
Pmax. at
100-300
rpm bar
Pmax. at
>300 rpm bar
L mm Weight kg
Product Name Flow rate max. L/min Displacement cc Speed min. rpm Speed max. rpm Torque max. N-m Pressure drop max. bar Pmax. at
0-100
rpm bar
Pmax. at
100-300
rpm bar
Pmax. at
>300 rpm bar
L mm Weight kg
HK EPMT 160 C 100 161,1 10 625 470 200 75 40 20 190 20,0
HK EPMT 200 C 125 201,4 10 625 590 200 75 40 20 195 22,5
HK EPMT 250 C 125 251,8 10 500 730 200 75 40 20 201 21,5
HK EPMT 315 C 125 326,3 10 380 950 200 75 40 20 211 22,0
HK EPMT 400 C 125 410,9 10 305 1080 180 75 40 20 221 23,0
HK EPMT 500 C 125 523,6 10 240 1220 160 75 40 - 235 24,0
Values for torque and pressure drop apply for continuous operation - pmax = max. pressure - max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.