HK EPRM CD

EPRM geroller motor

  • Image_1 Image_1
  • Image_2 Image_2
  • Image_3 Image_3

Properties

Connection Oil fittings: A + B = G 1/2"
Design Standard variant
Type "CD" with high-pressure gasket
Shaft Ø 25mm
two hole flange bolt circle 106.4
Intake and return pressure with leak oil line max. 175 bar
Leak oil connection G 1/4"

Article Table

Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
HK EPRM 050 CD 140 75 6.8 138 50 20 100 150 775 40 51.5 10
HK EPRM 080 CD 175 75 6.9 143 50 20 195 150 750 60 80.3 10
HK EPRM 100 CD 175 75 7.2 147 50 - 240 150 600 60 99.8 10
HK EPRM 125 CD 175 75 7.3 151 50 - 300 150 475 60 125.7 10
HK EPRM 160 CD 175 75 7.5 157 50 - 390 150 375 60 159.6 10
HK EPRM 200 CD 140 75 8.0 164 - - 385 150 300 60 199.8 10
HK EPRM 250 CD 110 75 8.4 173 - - 390 150 240 60 250.1 10
HK EPRM 315 CD 90 75 9.1 184 - - 390 150 190 60 315.7 10
HK EPRM 400 CD 70 75 9.8 198 - - 380 150 150 60 397.0 10
Values for torque and pressure drop apply for continuous operation
pmax = max. pressure
max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.