HK HM BMR HD

BMR HD CN geroller motor

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Connection Oil fittings: A + B = G 1/2"
Design Economy variant
Type "HD" with high-pressure gasket
Shaft Ø 25mm
two hole flange bolt circle 106.4
Intake and return pressure with leak oil line max. 175 bar
Leak oil connection M12 - plug

Article Table

Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar Weight kg L mm Pmax. at 300-600 rpm bar Pmax. at 600 rpm bar Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min
HK HM BMR 050 HD 140 75 6.5 139 50 20 93 150 775 40 51.7 10
HK HM BMR 080 HD 140 75 6.9 144 50 20 152 150 750 60 80.5 10
HK HM BMR 100 HD 140 75 7.0 148 50 20 194 150 600 60 100.5 10
HK HM BMR 125 HD 140 75 7.3 152 50 20 237 150 475 60 126.3 10
HK HM BMR 160 HD 140 75 7.5 158 50 20 300 150 375 60 160.8 10
HK HM BMR 200 HD 140 75 8.0 165 50 20 370 150 300 60 200.9 10
HK HM BMR 250 HD 110 75 8.5 174 - - 370 150 240 60 252.6 10
HK HM BMR 315 HD 90 75 9.0 186 - - 370 150 190 60 321.5 10
HK HM BMR 400 HD 70 75 11.0 200 - - 370 150 160 60 401.9 10
Values for torque and pressure drop apply for continuous operation
pmax = max. pressure
max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.