HK HM BMS

BMS CN geroller motor

  • Image_1 Image_1
  • Image_2 Image_2
  • Image_3 Image_3

Properties

Connection Oil fittings: A + B = G 1/2"
Design Economy variant
Shaft Ø 32mm
Four hole flange bolt circle 106,4
always connect drain line
Intake and return pressure with leak oil line max. 210 bar
Leak oil connection G 1/4"

Hints

It is generally recommended that the leak oil line is connected!

Article Table

Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar L mm Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min Pmax. at 300 rpm bar Weight kg
Product Name Pressure drop max. bar Pmax. at 100-300 rpm bar L mm Torque max. Nm Pmax. at 0-100 rpm bar Speed max. r/min Flow rate max. l/min Displacement cm³ Speed min. r/min Pmax. at 300 rpm bar Weight kg
HK HM BMS 080 175 50 167 194 100 810 65 80.5 10 20 9.800
HK HM BMS 100 175 50 170 242 100 750 75 100.5 10 20 10.000
HK HM BMS 125 175 50 175 303 100 600 75 126.3 8 20 10.300
HK HM BMS 160 160 50 181 358 100 470 75 160.8 8 20 10.700
HK HM BMS 200 160 50 188 438 100 375 75 200.9 8 20 11.100
HK HM BMS 250 125 50 197 440 100 300 75 252.6 8 - 11.600
HK HM BMS 315 125 50 208 530 100 240 75 321.5 8 - 12.300
HK HM BMS 400 100 50 222 562 100 180 75 401.9 8 - 13.200
Values for torque and pressure drop apply for continuous operation
pmax = max. pressure
max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.