HK HM BMT

BMT CN geroller motor



Properties

Connection Oil fittings: A + B = G 3/4"; leak oil = G 1/4"
Design always connect drain line, Economy variant / short shaft, Four hole flange bolt circle 160, Shaft Ø 40mm, length 60mm

Hints

It is generally recommended that the leak oil line is connected!

Article Table

Product Name Flow rate max. L/min Displacement cc Speed min. rpm Speed max. rpm Torque max. N-m Pressure drop max. bar Pmax. at
0-100
rpm bar
Pmax. at
100-300
rpm bar
Pmax. at
>300 rpm bar
L mm Weight kg
Product Name Flow rate max. L/min Displacement cc Speed min. rpm Speed max. rpm Torque max. N-m Pressure drop max. bar Pmax. at
0-100
rpm bar
Pmax. at
100-300
rpm bar
Pmax. at
>300 rpm bar
L mm Weight kg
HK HM BMT 160 100 158,8 10 625 450 200 75 40 20 210 20,3
HK HM BMT 200 125 200,8 10 625 560 200 75 40 20 215 20,8
HK HM BMT 250 125 252,2 10 500 710 200 75 40 20 220 21,4
HK HM BMT 315 125 317,5 10 280 900 200 75 40 20 227 22,4
HK HM BMT 400 125 401,6 10 305 1000 180 75 40 20 236 23,0
HK HM BMT 500 125 535,5 10 240 1120 160 75 40 - 255 24,0
Values for torque and pressure drop apply for continuous operation - pmax = max. pressure - max. pressure on shaft seal (without leak oil line) or pressure in leak oil line

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.