HK V2 190

V2190 lowering valve

  • Image_1 Image_1
  • Image_2 Image_2
  • Image_3 Image_3

Properties

Design single-acting
Material Inside parts of steel
Housing: Galvanised steel
Max. operating pressure max. 350 bar

Hints

When using these valve with a plunger cylinder, an additional pressure relief valve must be installed in the V1 line that has to be matched to the load pressure of the cylinder. This pressure relief valve must discharge to the tank.
These rate-of-drop valves must be set according to the application.

Article Table

Product Name L1 mm L2 mm L mm L3 mm H mm Thread Weight kg Q max. l/min S mm Level control ratio
Product Name L1 mm L2 mm L mm L3 mm H mm Thread Weight kg Q max. l/min S mm Level control ratio
HK V2 190 A600 148 30 100 60 60 G 3/8" 1.21 40 30 1:4
HK V2 190 A800 148 35 100 65 60 G 1/2" 1.15 60 30 1:4

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.