HK V2 575

Flow control check valve



Properties

Design Steel version with precision valve spindle, suitable for control panel installation
Operating pressure up to 400 bar

Description

Precise volumetric flow control or barring in one flow direction, free flow in the opposite direction
Metallic seal without leakage, linear opening cross-section
Precise throttling over a wide flow rate range
Opening pressure of the non-return valve 0.35 bar
Setting is as for the throttle valve
The hex. socket head screw in the setting knob serves for locking
An additional lock nut is available for control panel installation

Hints

These valves must be set according to the application.

Article Table

Product Name Flow rate max. L/min Pressure bar A mm B mm C mm D mm Thread Weight kg
Product Name Flow rate max. L/min Pressure bar A mm B mm C mm D mm Thread Weight kg
HK V2 575-1/8 8 400 50 64 16 13,5 G 1/8” 0,13
HK V2 575-1/4 14 400 66 78 20 17,0 G 1/4” 0,25
HK V2 575-3/8 38 400 79 93 25 19,5 G 3/8” 0,50
HK V2 575-1/2 50 400 95 107 30 21,0 G 1/2” 0,75
HK V2 575-3/4 80 400 115 132 40 26,5 G 3/4” 1,60
HK V2 575-1 190 320 139 167 50 35,0 G 1" 3,05
HK V2 575-11/4 200 320 157 172 55 35,0 G 1.1/4” 3,75
HK V2 575-11/2 350 320 190 181 65 35,0 G 1.1/2” 5,76
HK V2 575-2 450 320 228 202 75 44,0 G 2" 10,00
Values for max. flow rate at Δp = 20 bar

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.