HK V6 215 DBV

Flow control valve with secondary pressure relief



Properties

Design pressure-compensated, with additional secondary pressure relief valve
Material Housing: Cast iron, Inside parts of steel
Operating pressure max. 250 bar

Description

With these 3-way flow control valves, the preferred oil flow (P) is held constant irrespective of the incoming oil flow (IN). The residual oil flow (B) can be diverted to the tank or used for an ancillary consumer
Division: max. 75 % of quantity from IN to P, min. 5 l/min to P

Hints

These valves must be set according to the application.

Article Table

Product Name Thread IN/B Thread P Inlet max. L/min Width mm Height mm Length mm Weight kg
Product Name Thread IN/B Thread P Inlet max. L/min Width mm Height mm Length mm Weight kg
HK V6 215 0321 G 1/2” G 3/8” 40 65 110 87 1,40
HK V6 215 0323 G 3/4” G 1/2” 70 80 125 106 1,84

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.