HW 200 (2SN)

Hot water hose


Properties

Outer layer environmentally safe synthetic rubber
Insert two high tensile steel wire braided inserts
Application High pressure cleaning equipment
Colour black
Inner layer water, oil and heat resistant synthetic rubber
Elongation + 2 % to - 4 %
Media Mineral oil (up to + 100°C), Water, Water-oil emulsions
Standard EN 853 2 SN

Hints

The change in length of the hose is determined at max. working pressure during testing to EN ISO 1402.

Article Table

Product Name DN* Inches Size Internal Ø mm External Ø mm Operating pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Inches Size Internal Ø mm External Ø mm Operating pressure bar Burst pressure bar Min. bending radius mm
HW 206 6 1/4" 4 6,4 15,0 400,0 1840 100
HW 208 8 5/16" 5 7,9 16,6 400,0 1470 115
HW 210 10 3/8" 6 9,5 19,0 400,0 1320 130
HW 213 12 1/2" 8 12,7 22,2 400,0 1200 180
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.