MD 100

Medium pressure hose


Properties

Outer layer one textile braided insert embedded in synthetic rubber
Insert one textile braided insert and one steel wire braid
Application Low and medium pressure circuits
Colour black
Inner layer oil resistant synthetic rubber
Media Mineral oil, Polyglycol based oil, Water (0°C to + 70°C), Water-oil emulsions
Standard SAE 100 R 5

Article Table

Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
MD 104 5 4 3/16" 4,8 5,5 12,7 13,7 207,0 414 827 76
MD 106 6 5 1/4" 6,4 7,2 14,3 15,3 207,0 414 827 95
MD 108 8 6 5/16" 7,9 8,7 16,7 17,6 155,0 310 620 102
MD 110 10 8 - 10,3 11,1 18,9 20,0 138,0 276 552 117
MD 113 12 10 1/2" 12,7 13,7 22,8 24,0 121,0 241 483 140
MD 116 16 12 5/8" 15,9 17,0 26,8 28,0 103,0 207 414 165
MD 120 22 16 7/8" 22,2 23,3 30,6 32,2 55,0 110 221 187
MD 125 28 20 - 28,6 29,8 37,3 38,9 43,0 86 172 229
MD 132 35 24 1.3/8" 34,9 36,1 43,7 45,2 34,0 69 138 267
MD 140 38 32 - 46,0 47,2 55,2 57,6 24,0 48 97 337
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.