MD 100 AC

Coolant hose


Properties

Outer layer CR = Moisture absorption values 75% lower than required according to SAEJ2064
Design for screw fittings
Insert very strong steel wire braid
Application Coolant (air conditioning technology)
Colour black
Inner layer Butyl = R134a effusion values 65% lower than required according to SAEJ2064.
Media Compressor oils: PAG, ester only for TRITON SE55, SEZ80, Solest oil 35 / 68, Coolants: R134a
Standard SAE J2064

Article Table

Product Name DN* Size Inches Internal Ø mm External Ø mm Operating pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø mm External Ø mm Operating pressure bar Burst pressure bar Min. bending radius mm
MD 120 AC 22 16 7/8" 22,8 31,3 35,0 175 160
MD 125 AC 28 20 - 29,3 38,3 35,0 175 195
MD 132 AC 35 24 1.3/8" 35,5 45,6 35,0 175 225
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.