ND 300

Low pressure hose with textile insert


Properties

Outer layer oil resistant and weatherproof synthetic rubber
Insert one braided textile insert
Application Low pressure circuits (no pressure surge loads or critical applications), Pneumatic controllers, Return hoses
Colour black
Inner layer oil resistant synthetic rubber
Media Air, Mineral oil, Polyglycol based oil, Water (0°C to + 70°C), Water-oil emulsions
Standard EN 854 R6, SAE 100 R 6, DN 25 is not specified in the standard

Article Table

Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
ND 306 6 4 1/4" 5,9 6,9 11,9 13,5 28,0 56 112 65
ND 310 10 6 3/8" 9,0 10,0 15,1 16,7 28,0 56 112 80
ND 313 12 8 1/2" 12,1 13,3 19,0 20,6 28,0 56 112 100
ND 316 16 10 5/8" 15,3 16,5 22,2 23,8 24,0 48 96 125
ND 320 19 12 3/4" 18,2 19,8 25,4 27,8 21,0 41 83 150
ND 325 25 16 1" 24,6 26,2 - - 13,0 - 97 152
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.