ND DGV MG

Gate valve

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Connection 1 + 2 metric cylindrical outer thread
Material Brass
Scope of supply with union nut and cutting ring
Sealing form 1 + 2 24° inner cone
Temp. range mineral oils and fuel oil grades EL and L, 6 bar and up to 80 °C
Water: 0 °C to +80 °C

Article Table

Product Name L1 mm L2 mm SF* DN* L mm L3 mm Operating pressure bar AF mm Series Ø D mm Ø d2 mm
Product Name L1 mm L2 mm SF* DN* L mm L3 mm Operating pressure bar AF mm Series Ø D mm Ø d2 mm
ND DGV NW 04 HL MG 88 63 1.5 5 117 7 10.0 14 L 50 6
ND DGV NW 06 HL MG 88 63 1.5 6 117 7 10.0 17 L 50 8
ND DGV NW 08 HL MG 90 63 1.5 8 119 7 10.0 19 L 50 10
ND DGV NW 10 HL MG 90 63 1.5 10 119 7 10.0 22 L 50 12
ND DGV NW 13 HL MG 93 65 1.5 12 123 8 10.0 27 L 50 15
ND DGV NW 16 HL MG 94 67 1.5 16 126 8 10.0 32 L 50 18
ND DGV NW 20 HL MG 108 67 1.5 20 140 8 10.0 36 L 60 22
ND DGV NW 25 HL MG 125 95 1.5 25 158 10 10.0 41 L 60 28
ND DGV NW 32 HL MG 145 102 1.5 32 188 10 10.0 50 L 70 35
DN = Nominal diameter, nominal width
d2 = for external pipe diameter
AF = Width across flats
SF = Safety factor

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.