NY 800 NC (R8)

Thermoplastic high pressure hose, electrically nonconductive


Properties

Outer layer Polyurethane
Special features high ozone and abrasion resistance, slight volumetric expansion, very good reverse bending fatigue strength
Insert one aramide braided insert
Application general application, High pressure circuits
Colour orange
Inner layer Polyester elastomer
Elongation + 0 % to - 1 %
Media Mineral oil, Synthetic oils, Water (0°C to + 60°C), Water-oil emulsions (up to 60‏°C)
Standard SAE J517 - 100 R8 Non Conductive

Description

Electrical conductivity < 50μA to DIN EN 855

Hints

Electrical conductivity < 50μA to DIN EN 855

Article Table

Product Name DN* Size Inches Internal Ø mm External Ø mm Operating pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø mm External Ø mm Operating pressure bar Burst pressure bar Min. bending radius mm
NY 804 NC 5 3 3/16" 5,0 8,9 350,0 1400 30
NY 806 NC 6 4 1/4" 6,5 11,5 350,0 1400 50
NY 808 NC 8 5 5/16" 8,1 13,4 300,0 1200 55
NY 810 NC 10 6 3/8" 9,7 15,5 280,0 1120 60
NY 813 NC 12 8 1/2" 13,0 19,9 245,0 980 80
NY 820 NC 19 12 3/4" 19,5 26,9 165,0 660 150
NY 825 NC 25 16 1" 25,9 34,2 140,0 560 200
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.