PHD

Piston packing set for one-piece pistons PHD

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Anwendung Hydraulics
Design Piston packing set
Installation on one-piece pistons A, on multi-part pistons B
Material (3) Back ring: acetal resin, (1) Static seal: NBR, (2) Dynamic seal: PTBR
Max. operating pressure up to 400 bar
Media Mineral oil, Water emulsions
Online-Shop https://shop.hansa-flex.com/de/PHD
Sliding speed max. 1.5 m/s
Temp. max. 110 °C
Temp. min. 30 °C

Description

Low spatial requirement.
High resistance to extrusion.
High abrasion resistance.
Low-friction seal.

Article Table

Product Name D mm d mm L mm
Product Name D mm d mm L mm
PHD5036 50 mm 36 mm 9.0 mm
PHD5541 55 mm 41 mm 9.0 mm
PHD6046 60 mm 46 mm 9.0 mm
PHD6050 60 mm 50 mm 8.0 mm
PHD6348 63 mm 48 mm 11.0 mm
PHD6550 65 mm 50 mm 11.0 mm
PHD7055 70 mm 55 mm 11.0 mm
PHD7560 75 mm 60 mm 11.0 mm
PHD8065 80 mm 65 mm 11.0 mm
PHD8570 85 mm 70 mm 11.0 mm
PHD9075 90 mm 75 mm 11.0 mm
PHD9580 95 mm 80 mm 11.0 mm
PHD10085 100 mm 85 mm 12.5 mm
PHD10590 105 mm 90 mm 12.5 mm
PHD11095 110 mm 95 mm 12.5 mm
PHD115100 115 mm 100 mm 12.5 mm
PHD120105 120 mm 105 mm 12.5 mm
PHD125102 125 mm 102 mm 16.0 mm
PHD130107 130 mm 107 mm 16.0 mm
PHD135112 135 mm 112 mm 16.0 mm
PHD140117 140 mm 117 mm 16.0 mm
PHD145122 145 mm 122 mm 16.0 mm
PHD150127 150 mm 127 mm 16.0 mm
PHD160137 160 mm 137 mm 16.0 mm
PHD165142 165 mm 142 mm 16.0 mm
PHD180157 180 mm 157 mm 16.0 mm

Order hints

Dichtungen mit Durchmesser 20 bis 510 mm können wir kurzfristig anfertigen.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.