PHN 200

Swage ferrule for braided hose



Properties

Ferrule type Non-skive ferrule
suitable for 1SN (HD 100), 2SC (KP 200), 2SN (HD 200)
Surface electro galvanised
Material Steel

Description

for:
- 1SN (HD 100)
- 2SN (HD 200)

Hints

The ferrule assignment depends on the hose type.

Article Table

Product Name DN* Size Inches D1 mm D3 mm LF mm
Product Name DN* Size Inches D1 mm D3 mm LF mm
PHN 204 5 3 3/16" 21,0 9,5 23,5
PHN 206 6 4 1/4" 23,0 11,4 30,0
PHN 208 8 5 5/16" 24,0 13,2 30,0
PHN 210 10 6 3/8" 26,0 14,5 31,0
PHN 213 12 8 1/2" 29,0 18,3 32,0
PHN 216 16 10 5/8" 33,0 21,6 36,0
PHN 220 19 12 3/4" 37,0 24,4 42,5
PHN 225 25 16 1" 46,0 31,0 51,0
PHN 232 31 20 1.1/4" 59,0 38,3 57,5
PHN 240 38 24 1.1/2" 67,0 44,0 60,5
PHN 250 51 32 2" 80,0 57,0 74,0
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.