PHT

Pressed holder for textile braid hose

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Ferrule type Non-skive ferrule
Material Steel
Surface electro galvanised
geeignet für 2TE (TE 200, TE 200B,), 3TE (TE 300), SI 200 RME

Hints

Die Zuordnung der Fassung ist abhängig vom Schlauchtyp.
PHT204 für 2TE (TE200, TE200B) PHT304 für 3TE (TE300)

Article Table

Product Name DN* LF mm D3 mm Zoll D1 mm Size
Product Name DN* LF mm D3 mm Zoll D1 mm Size
PHT204 5 27.3 mm 9.8 mm 3/16" 17.0 mm 3
PHT304 5 27.3 mm 9.8 mm 3/16" 18.6 mm 3
PHT06 6 28.0 mm 11.6 mm 1/4" 19.0 mm 4
PHT08 8 30.2 mm 12.6 mm 5/16" 22.3 mm 5
PHT10 10 29.5 mm 14.9 mm 3/8" 23.0 mm 6
PHT13 12 31.0 mm 18.5 mm 1/2" 27.0 mm 8
PHT16 16 33.0 mm 21.8 mm 5/8" 32.0 mm 10
PHT20 19 37.5 mm 24.6 mm 3/4" 35.0 mm 12
PHT25 25 45.5 mm 30.8 mm 1" 42.0 mm 16
PHT32 31 55.0 mm 37.9 mm 1.1/4" 48.0 mm 20
PHT40 38 63.2 mm 44.2 mm 1.1/2" 57.2 mm 24
PHT50 51 78.5 mm 56.8 mm 2" 76.0 mm 32
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.