PHT 300 VA

Pressed holder for textile braid hose

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Ferrule type Non-skive ferrule
Material Stainless steel

Hints

The ferrule assignment depends on the hose type.

Article Table

Product Name DN* LF mm D3 mm Inches D1 mm Size
Product Name DN* LF mm D3 mm Inches D1 mm Size
PHT 340 VA 38 70.0 45.1 1.1/2" 60.0 24
PHT 350 VA 51 80.0 57.4 2" 76.0 32
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.