SI 100

Fuel hose with braiding

  • Image_1 Image_1

Properties

Application area Low pressure hose for fuel lines
Colour metallic
Inner layer oil resistant synthetic rubber
Insert one zinc plated steel wire braided insert
Media Crude oil
Lubricating oil
Lubricating oil
nicht für Ottokraftstoffe geeignet
Outer layer none
Standard DIN EN ISO 6806
Temp. max. 80 °C
Temp. min. -35 °C

Article Table

Product Name External Ø nom. mm Internal Ø nom. mm DN* Test pressure bar Unit Roll length m Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
Product Name External Ø nom. mm Internal Ø nom. mm DN* Test pressure bar Unit Roll length m Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
SI 103 9.5 4.5 3 30 Reel 50 20 Yes 1/8" 60 2 25
SI 104 10.5 5.5 4 30 Reel 50 20 Yes 3/16" 60 3 25
SI 106 12.5 7.5 6 25 Reel 50 15 Yes 1/4" 50 4 30
SI 108 14.0 9.0 8 25 Reel 50 15 Yes 5/16" 50 5 40
SI 110 18.0 11.5 10 25 Reel 50 15 Yes 3/8" 50 6 45
SI 113 22.0 14.5 12 25 Reel 50 15 Yes 1/2" 50 8 50
SI 116 25.0 17.0 16 25 Reel 50 15 Yes 5/8" 50 10 70
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.