SI 300

Fuel hose with braiding

  • Image_1 Image_1

Properties

Application area Low pressure hose for fuel lines
Colour metallic
Inner layer oil resistant synthetic rubber
Insert one textile braided insert and one zinc plated steel wire braided insert
Media Petrol fuels
Crude oil
Lubricating oil
Lubricating oil
Outer layer none
Standard DIN 73379
Temp. max. 80 °C
Temp. min. -35 °C

Article Table

Product Name External Ø nom. mm Internal Ø nom. mm DN* Test pressure bar Unit Roll length m Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
Product Name External Ø nom. mm Internal Ø nom. mm DN* Test pressure bar Unit Roll length m Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
SI 304 11.5 5.5 4 40 Reel 20 30 Yes 3/16" 60 3 40
SI 306 13.5 7.5 6 40 Reel 20 30 Yes 1/4" 60 4 50
SI 308 16.0 9.0 8 35 Reel 20 25 Yes 5/16" 45 5 60
SI 310 18.5 11.5 10 35 Reel 20 25 Yes 3/8" 45 6 80
SI 313 23.0 15.0 12 35 Reel 20 25 Yes 1/2" 45 8 80
SI 316 26.0 17.5 16 35 Reel 20 25 Yes 5/8" 45 10 120
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.