SRD MG

Cutting ring



Properties

Design Cutting ring
Standard DIN 3861
Material Brass

Hints

Information about fitting, installation, pressure loads and permissible operating temperatures can be found in the technical information for pipe fittings.

Article Table

Product Name Series Ø d2 mm L1 mm
Product Name Series Ø d2 mm L1 mm
SRD 04 LL MG LL 4 6,0
SRD 05 LL MG LL 5 7,0
SRD 06 LL MG LL 6 7,0
SRD 08 LL MG LL 8 7,0
SRD 10 LL MG LL 10 7,0
SRD 12 LL MG LL 12 7,5
SRD 06 MG S 6 9,5
SRD 08 MG S 8 9,5
SRD 10 MG S 10 10,0
SRD 12 MG S 12 10,0
SRD 14 MG S 14 10,0
SRD 15 MG L 15 10,0
SRD 16 MG S 16 10,5
SRD 18 MG L 18 10,0
SRD 20 MG S 20 12,5
SRD 22 MG L 22 10,5
SRD 25 MG S 25 12,5
SRD 28 MG L 28 10,5
SRD 30 MG S 30 13,0
SRD 35 MG L 35 13,0
SRD 38 MG S 38 13,5
SRD 42 MG L 42 13,0
Series: LL = Very light L = Light S = Heavy - PN = Nominal pressure PB = Max. operating pressure - Ø d2 = External pipe diameter

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.