SW MG

Bulkhead fitting, angle 90

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Connection 1 + 2 metric cylindrical outer thread
Construction Angle 90°
Design Bulkhead fitting
Material Brass
Scope of supply Socket with union nut and cutting ring
Sealing form 1 + 2 24° inner cone
Standard DIN 2353
ISO 8434-1

Hints

Information about fitting, installation, pressure loads and permissible operating temperatures can be found in the technical information for pipe fittings.

Article Table

Product Name L2 mm b mm S2 L5 mm L1 mm S1 L4 mm L3 mm External pipe Ø mm Operating pressure AF mm G1 Series Ø D mm Ø d2 mm
Product Name L2 mm b mm S2 L5 mm L1 mm S1 L4 mm L3 mm External pipe Ø mm Operating pressure AF mm G1 Series Ø D mm Ø d2 mm
SW NW 04 HL MG 27.0 16 14 14 42 17 12.0 27 6 PN 200 12 M 12 x 1,5 L 17 6
SW NW 06 HL MG 27.0 16 17 17 42 19 14.0 29 8 PN 200 12 M 14 x 1.5 L 19 8
SW NW 08 HL MG 28.0 16 19 18 43 22 15.0 30 10 PN 200 14 M 16 x 1.5 L 22 10
SW NW 10 HL MG 29.0 16 22 20 44 24 17.0 32 12 PN 200 17 M 18 x 1.5 L 24 12
SW NW 13 HL MG 31.0 16 27 23 46 30 21.0 36 15 PN 200 19 M 22 x 1.5 L 27 15
SW NW 16 HL MG 32.5 16 32 24 49 36 23.5 40 18 PN 200 24 M 26 x 1.5 L 32 18
Series: LL = Very light L = Light S = Heavy
PN = Nominal pressure
Ø d2 = External pipe diameter
SW, S1, S2, S3 = With across flats

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.