TE 200 (2TE)

Low pressure hose with textile insert


Properties

Outer layer oil resistant and weatherproof synthetic rubber
Insert one or two textile braided inserts
Application Low pressure hose for general applications.
Colour black
Inner layer oil resistant synthetic rubber
Elongation + 2 % to - 4 %
Media Glycol, Mineral oil, Water (0°C to + 70°C), Water-oil emulsions
Standard EN 854 2 TE

Hints

The change in length of the hose is determined at max. working pressure during testing to EN ISO 1402.

Article Table

Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
TE 225 25 16 1" 24,6 26,2 32,9 35,9 40,0 80 160 130
TE 232 31 20 1.1/4" 30,8 32,8 - - 35,0 70 140 140
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.