TE 200 B (2TE)

Low pressure hose with textile insert


Properties

Outer layer flame retardant, oil resistant, weatherproof synthetic rubber
Special features (test reports on request), Fire tested to DIN 54 837 with DIN 5510 Part 2 classification
Insert one or two textile braided inserts
Application Low pressure hose for general applications.
Colour black
Inner layer oil resistant synthetic rubber
Media Glycol, Mineral oil, Water (0°C to + 70°C), Water-oil emulsions
Standard EN 854 2 TE

Article Table

Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
Product Name DN* Size Inches Internal Ø min. mm Internal Ø max. mm External Ø min. mm External Ø max. mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm
TE 204 B 5 3 3/16" 4,5 5,2 10,0 11,6 80,0 160 320 35
TE 206 B 6 4 1/4" 5,9 6,9 12,6 14,2 75,0 150 300 40
TE 208 B 8 5 5/16" 7,4 8,4 14,1 15,7 68,0 136 272 50
TE 210 B 10 6 3/8" 9,0 10,0 15,7 17,3 63,0 126 252 60
TE 213 B 12 8 1/2" 12,1 13,3 18,7 20,7 58,0 116 232 70
TE 216 B 16 10 5/8" 15,3 16,5 22,9 24,9 50,0 100 200 90
TE 220 B 19 12 3/4" 18,2 19,8 26,0 28,0 45,0 90 180 110
TE 225 B 25 16 1" 24,6 26,2 32,9 35,9 40,0 80 160 150
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.