TE 300 B (3TE)

Low pressure hose with textile insert


Properties

Outer layer flame retardant, oil resistant, weatherproof synthetic rubber
Special features (test reports on request), Fire tested to DIN 54 837 with DIN 5510 Part 2 classification
Insert two textile braided inserts
Application Low pressure hose for general applications.
Colour black
Inner layer synthetic rubber NBR
Media Air (up to + 70°C), light heating oil, Lubricating oil, Mineral oil base, Water, Water-glycol emulsions
Standard EN 854 3 TE

Article Table

Product Name DN* Size Inches Internal Ø mm External Ø mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm Colour
Product Name DN* Size Inches Internal Ø mm External Ø mm Operating pressure bar Test pressure bar Burst pressure bar Min. bending radius mm Colour
TE 306 B 6 4 1/4" 6,4 14,4 145,0 290 580 45 black
TE 308 B 8 5 5/16" 7,9 16,9 130,0 260 260 55 black
TE 310 B 10 6 3/8" 9,5 18,5 110,0 220 440 70 black
TE 313 B 12 8 1/2" 12,7 21,7 93,0 189 370 85 black
TE 316 B 16 10 5/8" 15,6 25,9 80,0 160 320 105 black
TE 320 B 19 12 3/4" 19,0 29,0 70,0 140 280 130 black
TE 325 B 25 16 1" 25,4 35,9 55,0 110 220 150 black
TE 332 B 31 20 1.1/4" 31,8 42,3 45,0 90 180 190 black
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.