TS AI

Rod seal TS-AI

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Application Hydraulics
Design Rod U-ring
Installation in closed grooves A
in open grooves B
Material (1) Seal: PUR
(2) Support ring: acetal resin / PTBR
Max. operating pressure up to 500 bar
Media Mineral oil
Sliding speed max. 0.5 m/s
Temp. max. 80 °C
Temp. min. -30 °C

Description

High abrasion resistance.
Extremely good sealing effect at low pressure.
Fast alternation of loads.

Article Table

Product Name D mm d mm L mm
Product Name D mm d mm L mm
TS 25 36-AI 36 25 6.0
TS 70 80-2-AI 80 70 13.0

Order hints

We are able to produce seals with diameters of 20 to 510 mm with short lead times.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.