NY 100

Thermoplastic high pressure hose

  • Image_1 Image_1

Properties

Application area medium high pressure circuits
High pressure lubrication lines
Agricultural machines
Forklift trucks
Colour black
Elongation + 2 % to - 4 %
Inner layer Polyester elastomer
Insert one high tensile steel wire braided insert
Media Mineral oil
Polyglycol based oil
Water (0°C to + 60°C)
Water-oil emulsions (up to 60‏°C)
Outer layer Polyurethane (PUR)
Special features high ozone and abrasion resistance
good chemical resistance
low volumetric expansion
Temp. max. 100 °C
Temp. min. -40 °C

Hints

The change in length of the hose is determined at max. working pressure during testing to EN ISO 1402.

Article Table

Product Name External Ø nom. mm Internal Ø nom. mm DN* Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
Product Name External Ø nom. mm Internal Ø nom. mm DN* Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
NY 104 9.3 5.0 5 300 3/16" 1200 3 25
NY 106 11.5 6.0 6 300 1/4" 1200 4 35
NY 108 13.3 8.0 8 225 5/16" 900 5 40
NY 110 15.0 10.0 10 225 3/8" 900 6 60
NY 113 18.3 12.0 12 180 1/2" 655 8 70
NY 116 21.6 16.0 16 140 5/8" 540 10 110
NY 120 26.7 19.4 19 125 3/4" 500 12 170
NY 125 33.5 25.0 25 100 1" 400 16 230
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.