NY 800 (R8)

Thermoplastic high pressure hose

  • Image_1 Image_1

Properties

Application area High pressure circuits
general application
Colour black
Elongation + 3 % to - 3 %
Inner layer Polyester elastomer
Insert one aramide braided insert
Media Mineral oil
Applications with gaseous or chemical media
Synthetic oils
Water (0°C to + 60°C)
Water-oil emulsions (up to 60‏°C)
Outer layer Polyurethane (PUR)
Special features high ozone and abrasion resistance
no swelling or brittleness when used with solvents or alkaline media
very good reverse bending fatigue strength
slight volumetric expansion
Standard SAE 100 R 8, BS 4983, ISO 3949
Temp. max. 100 °C
Temp. min. -40 °C

Hints

The change in length of the hose is determined at max. working pressure during testing to EN ISO 1402.

Article Table

Product Name External Ø nom. mm Internal Ø nom. mm DN* Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
Product Name External Ø nom. mm Internal Ø nom. mm DN* Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
NY 804 8.9 5.0 5 350 3/16" 1400 3 30
NY 806 11.5 6.5 6 350 1/4" 1400 4 50
NY 808 13.4 8.1 8 300 5/16" 1200 5 55
NY 810 15.5 9.7 10 280 3/8" 1120 6 60
NY 813 19.9 13.0 12 245 1/2" 980 8 80
NY 820 26.9 19.5 19 165 3/4" 660 12 150
NY 825 34.2 25.9 25 140 1" 560 16 200
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.