NY 800 NC (R8)

Thermoplastic high pressure hose, electrically nonconductive

  • Image_1 Image_1

Properties

Application area High pressure circuits
general application
Colour orange
Elongation + 0 % to - 1 %
Inner layer Polyester elastomer
Insert one aramide braided insert
Media Mineral oil
Synthetic oils
Water-oil emulsions (up to 60‏°C)
Water (0°C to + 60°C)
Outer layer Polyurethane (PUR)
Special features high ozone and abrasion resistance
very good reverse bending fatigue strength
slight volumetric expansion
Standard SAE J 517 - 100 R8 Non Conductive
Temp. max. 100 °C
Temp. min. -40 °C

Hints

Electrical conductivity 50μA to DIN EN 855

Article Table

Product Name External Ø nom. mm Internal Ø nom. mm DN* Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
Product Name External Ø nom. mm Internal Ø nom. mm DN* Operating pressure bar Inches Burst pressure bar Size Min. bending radius mm
NY 804 NC 8.9 5.0 Thermoplastic high pressure hose, electrically nonconductive 5 350 3/16" 1400 3 30
NY 806 NC 11.5 6.5 Thermoplastic high pressure hose, electrically nonconductive 6 350 1/4" 1400 4 50
NY 808 NC 13.4 8.1 Thermoplastic high pressure hose, electrically nonconductive 8 300 5/16" 1200 5 55
NY 810 NC 15.5 9.7 Thermoplastic high pressure hose, electrically nonconductive 10 280 3/8" 1120 6 60
NY 813 NC 19.9 13.0 Thermoplastic high pressure hose, electrically nonconductive 12 245 1/2" 980 8 80
NY 820 NC 26.9 19.5 Thermoplastic high pressure hose, electrically nonconductive 19 165 3/4" 660 12 150
NY 825 NC 34.2 25.9 Thermoplastic high pressure hose, electrically nonconductive 25 140 1" 560 16 200
DN = Nominal diameter, nominal width

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.