HK GR33

Gear pump, size 2, low noise

  • Image_1 Image_1
  • Image_2 Image_2
  • Image_3 Image_3

Properties

Design low noise
Material Housing: Aluminium
Front flange, end cover: Cast steel
Pitch circle pressure side 30 / M6
Pitch circle suction side 40 / M8

Description

European standard pump – hole pattern 96.2 x 71.5 – dia. 36.5 – taper 1:8 – flange fitting
Due to the special tooth design these pumps achieve a significantly lower noise level. (By comparison: standard gear pump 65-75 dB; gear pump HK GR33 47-57 dB; values for speed range 500-3000 rev/min)

Hints

Anzugsdrehmoment der Befestigungsmutter auf der Welle: 40 Nm

Article Table

Product Name VFU cm³ p1max. bar A mm Speed max. r/min p3max. bar Speed min. r/min Direction of rotation p2max. bar B mm Weight kg
Product Name VFU cm³ p1max. bar A mm Speed max. r/min p3max. bar Speed min. r/min Direction of rotation p2max. bar B mm Weight kg
HK GR33 2C 010 F2AC4 F D 10.0 275 122.5 3000 300 500 clockwise rotating 280 53.7 3.600
HK GR33 2C 013 F2AC4 F D 13.0 265 127.4 3000 290 500 clockwise rotating 270 56.2 3.800
HK GR33 2C 015 F2AC4 F D 15.0 240 132.4 3000 270 500 clockwise rotating 250 58.7 3.900
HK GR33 2C 018 F2AC4 F D 18.0 205 138.2 3000 270 500 clockwise rotating 250 61.6 4.000
VFU = conveying volume per revolution
p1 = continuous pressure
p2 = working pressure
p3 = maximum pressure

Order hints

Further pump versions available on request

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.