HK SP DG4V3

Coil for HK DG4V3 solenoid-operated valve

  • Image_1 Image_1

Properties

Corresponding connectors HKSP664, HKSP666, HKSP667, HKSP668, HKSP669 (rectifier plug)

Hints

As far as AC coils are concerned, power input is considerably higher in the take-up phase than in the stopping phase. These must therefore never be operated without a magnet core since there is a danger of overheating and the coil can burn through. A similar effect occurs if valves with AC magnets are operated with extremely high pulse frequencies (On / Off). In such cases the coils, which are often in the vicinity of the high power input, can also overheat. For such applications the use of RC coils with rectifier plugs is recommended.
With DC coils extremely high power spikes can occur during powering down. We therefore recommend the use of plugs with protective circuits when using such coils.
Tightening torque for attaching nuts of the solenoid coils: 3Nm

Article Table

Product Name Average power consumption W Nominal voltage +/- 10 % Weight kg
Product Name Average power consumption W Nominal voltage +/- 10 % Weight kg
HK DG4V3 G 12VDC 30 12 VDC 0.550
HK DG4V3 H 24VDC 30 24 VDC 0.550
HK DG4V3 A 110VAC 7 110 VAC 0.550
HK DG4V3 EP 230VAC 7 230 VAC 0.550

Order hints

Other types of coil on request

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.