HK SP EMDV

Coil for cartridge valve EMDV

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Corresponding connectors HKSP664, HKSP666, HKSP667, HKSP668

Description

Code contains coil, 2 part heat sink and type plate with fastenings. A rectifier plug has to be used for solenoid coils Type HK230VACSEMDV08. The solenoid coils Type HK230ACLEMDV1012 have a rectifier integrated into the coil.

Hints

As far as AC coils are concerned, power input is considerably higher in the take-up phase than in the stopping phase. These must therefore never be operated without a magnet core since there is a danger of overheating and the coil can burn through. A similar effect occurs if valves with AC magnets are operated with extremely high pulse frequencies (On / Off). In such cases the coils, which are often in the vicinity of the high power input, can also overheat. For such applications the use of RC coils with rectifier plugs is recommended.
With DC coils extremely high power spikes can occur during powering down. We therefore recommend the use of plugs with protective circuits when using such coils.

Article Table

Product Name Nominal voltage +/- 10 % Power consumption W for valve type Weight kg
Product Name Nominal voltage +/- 10 % Power consumption W for valve type Weight kg
HK 12VDC L EMDV 60191 Coil for cartridge valve EMDV 12 VDC 36 HK EMVD10 N01
HK EMVD10 NC1
HK EMDV 12
0.200
HK 12VDC S EMDV 60186 Coil for cartridge valve EMDV 12 VDC 22 HK EMDV 08 0.200
HK 230VAC L EMDV 60191 Coil for cartridge valve EMDV 230 VAC 36 HK EMVD10 N01
HK EMVD10 NC1
HK EMDV 12
0.200
HK 230VAC S EMDV 60186 Coil for cartridge valve EMDV 230 VAC 22 HK EMDV 08 0.200
HK 24VDC L EMDV 60191 Coil for cartridge valve EMDV 24 VDC 36 HK EMVD10 N01
HK EMVD10 NC1
HK EMDV 12
0.200
HK 24VDC S EMDV 60186 Coil for cartridge valve EMDV 24 VDC 22 HK EMDV 08 0.200

Order hints

Other types of coil on request

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.