DBM FPM

Piston packing set for one-piece pistons DBM-FPM

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Application Hydraulics
Design Piston packing set
Installation on one-piece or multi-part pistons
Material (2) Guide ring: acetal resin
(3) Support ring: Polyester
(1) Seal: FPM
Media Mineral oil
Water emulsions
Operating pressure 300 bar
Sliding speed max. 0.5 m/s
Temp. max. 110 °C
Temp. min. -30 °C

Description

Extremely good sealing effect at low pressure.
Easy assembly.
Simple solution.

Article Table

Product Name D mm L mm G mm P mm d mm M mm
Product Name D mm L mm G mm P mm d mm M mm
DBM 157 118 FPM 40 16.4 6.35 38.50 30 35.40
DBM 196 133 FPM 50 18.4 6.35 44.66 34 45.41
DBM 236 173 FPM 60 18.4 6.35 58.65 44 55.39
DBM 248 185 FPM 63 18.4 6.35 61.63 47 58.39
DBM 275 196 FPM 70 22.4 6.35 68.34 50 64.18
DBM 314 236 FPM 80 22.4 6.35 78.34 60 74.16
DBM 393 295 FPM 100 22.4 6.35 98.05 75 93.14

Order hints

Alternative material possible

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.