DS

Piston seal DS

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Application Hydraulics
Design U-ring packing set
Installation on multi-part pistons
Material (2) Seal: fabric-reinforced NBR
(1) Support ring: NBR
Media Mineral oil
Water emulsions
Operating pressure 250 bar
Sliding speed max. 0.5 m/s
Temp. max. 110 °C
Temp. min. -40 °C

Description

Low spatial requirement.
High resistance to extrusion.

Article Table

Product Name D mm L mm d mm
Product Name D mm L mm d mm
DS 940 47 24 7.5 12
DS 980 51 25 8.0 13
DS 157 098 40 10.0 25
DS 196 137 50 10.0 35
DS 216 1571 55 9.5 40
DS 216 157 55 12.0 40
DS 255 177 65 13.5 45
DS 275 196 70 13.5 50
DS 314 236 80 13.5 60
DS 354 275 90 13.5 70
DS 374 295 95 13.5 75
DS 590 492 150 14.0 125
DS 787 669 200 19.8 170
DS 886 767 225 19.8 195
DS 984 866 250 19.8 220
DS 118 11062 300 19.8 270

Order hints

Alternative material possible: FPM.
For special operating conditions (fluid, temperature, pressure ...) please contact us.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.