DR

Ice scraper DR

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Application Hydraulics
Design Wipers
Installation is pressed into an open groove
Material (1) Metallic wiper lip: brass (INOX optional)
(2) Elastomer wiper lip: NBR (FPM optional)
(3) Sleeve: steel (INOX optional)
(4) Distance pieces: steel (INOX optional)
Media Mineral oil
Water-air
Sliding speed max. 1.0 m/s
Temp. max. 120 °C
Temp. min. -40 °C

Description

Low spatial requirement.
Effective wiping under extreme conditions.
Suitable for ice, sludge and especially sticky particles.
The floating metallic wiper lip allows the rods to be offset.

Article Table

Product Name H mm D mm d mm L mm
Product Name H mm D mm d mm L mm
DR 14 6.5 27 14 7.0
DR 16 6.5 29 16 7.0
DR 20 6.5 33 20 7.0
DR 22 6.5 35 22 7.0
DR 25 6.5 38 25 7.0
DR 28 6.5 41 28 7.0
DR 30 7.0 43 30 7.5
DR 35 7.0 48 35 7.5
DR 36 7.0 49 36 7.5
DR 38 7.0 51 38 7.5
DR 40 7.0 53 40 7.5
DR 45 7.0 58 45 7.5
DR 50 7.5 64 50 8.0
DR 50-R-9975-R 7.5 64 50 8.0
DR 55 7.5 69 55 8.0
DR 60 7.5 74 60 8.0
DR 70 7.5 84 70 8.0
DR 75 7.5 89 75 8.0
DR 80 8.0 96 80 8.5
DR 90 8.0 106 90 8.5
DR 150 8.5 170 150 9.0

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.