DDEM P

Piston seal, DDEM-P

  • Image_1 Image_1
  • Image_2 Image_2

Properties

Application Hydraulics + pneumatics
Design Piston U-ring
Design Metric
Installation on one-piece pistons A
on multi-part pistons B
Material PUR 90° Shore A
Media Air
Operating pressure 16 bar
Sliding speed max. 1.0 m/s
Temp. max. 80 °C
Temp. min. -30 °C

Description

Low-friction seal.
Simple solution.

Article Table

Product Name D mm L mm d mm
Product Name D mm L mm d mm
DDEM 20 14-P 20 4.5 14
DDEM 25 17-P 25 5.5 17
DDEM 32 24-P 32 6.0 24
DDEM 40 30-P 40 7.5 30
DDEM 50 40-P 50 7.5 40
DDEM 55 45-P 55 7.5 45
DDEM 60 50-P 60 7.5 50
DDEM 63 53-P 63 7.5 53
DDEM 65 55-P 65 7.5 55
DDEM 70 58-P 70 9.5 58
DDEM 75 63-P 75 9.5 63
DDEM 80 68-P 80 9.5 68
DDEM 85 73-P 85 9.5 73
DDEM 90 78-P 90 9.5 78
DDEM 000 88-P 100 9.5 88
DDEM 100 95-P 110 11.0 95
DDEM 201 05-P 120 11.0 105
DDEM 25 110-P 125 11.0 110
DDEM 60 145-P 160 11.0 145
DDEM 80 160-P 180 15.0 160
DDEM 00 180-P 200 15.0 180

Order hints

We are able to produce seals with diameters of 20 to 510 mm with short lead times.

Disclaimer

Despite careful checking, we cannot guarantee the accuracy of all information included on this site, and we accept no liability.
All data and information in our online catalogue are based on currently valid standards and the regulations from the employer's liability insurance association. Product safety can only be guaranteed when our assembly instructions are carefully observed. Non-adherence to these regulations can affect product operation and functioning and result in a loss of warranty. Our warranty is only valid for HANSA-FLEX products. Our products are constantly subject to further development and technical changes are therefore possible.